wrong. banshee motors are no where near tall enough to accept that engine. You will need to cut the bottom of the frame and drop the motor down lower while still adding about 4inches to every vertical frame tube.
Yamaha raptor engines are very tall to begin with. These frames will accept a 4 cylinder street bike engine with much less cutting of the frame.
z400 and kfx400 can fit a gsxr 600 engine with only the top two horizontal frame tubes being widened to accpet the wider motor. not sure if that chassis will take a 750 or 1000 with that little labor though.
but banshee frame is not the easiest frame to work with. lots of people did it, but they endup looking like frankenbikes
|
