Cat 650 belt problems - ATV Forum - All Terrain Vehicle discussion for Honda, Yamaha and more ATVs

freddyfour · 12-08-2009, 04:44 PM

I have a 2006 Cat 650 V2 and I blew the belt on it a month back. I just put on the new belt today and the dash is still telling me there is no belt. I am also unable to drive faster then 15m/h, it feels like it is being restricted like it does in reverse.

Any ideas on what I haven't done right?

Trikemaster · 12-09-2009, 02:21 AM

Maybe, something is worn out

2006 Arctic Cat 650 V-Twin 4x4 FIS Auto OEM Parts, 2006 Arctic Cat 650 V-Twin 4x4 FIS Auto OEM ATV Parts - BikeBandit.com

Trikemaster · 12-09-2009, 02:25 AM

This might work for ya....

1. Turn the ignition switch to the OFF position; then
disconnect the 4-pin connector.
2. Connect the Reset Connector (p/n 0486-161) into
the forward 4-pin connector; then turn the ignition
switch to the ON position. The belt indicator light
should flash rapidly.
3. Disconnect the belt indicator light switch
connector. The light should flash slowly. Allow
the light to flash for 10 seconds before turning the
ignition switch off.
4. Turn the ignition switch to the OFF position; then
remove the reset connector.
5. Connect the 4-pin connector and the belt indicator
light switch connector; then turn the ignition
switch to the ON position. The belt indicator light
should go off.

or this:

1. Turn the ignition switch to the OFF position; then
disconnect the 4-pin connector and the belt indicator
light switch connector.
2. Install the Reset Connector (p/n 0486-161) into the
forward 4-pin connector; then turn the ignition
switch to ON. Allow the belt indicator light to
flash for 10 seconds or more; then turn the ignition
switch to OFF.
NOTE: The light will flash rapidly for 5 seconds;
then it will flash slowly. Allow the light to flash
slowly for at least 5 seconds before turning the
ignition switch off.
3. Remove the reset connector and connect the 4-pin
connectors and the belt indicator light switch
connector.
4. Turn the ignition switch to the ON position and
confirm

freddyfour · 12-09-2009, 06:46 PM

Ya I've seen this before but I am having no luck with it? Maybe I'm jumping the wrong wires. Anyone have a diagram they can post so I can see what I am doing wrong.

Trikemaster · 12-12-2009, 12:33 PM