I have not went out to look at the bike yet.
Yesterday after a ride i tried to put my bike in 2X4 to do some donuts on the ice and it would not go. I also noticed the light not on at all(4X4 light).
I am assuming there may be a fuse for this?
Any help would be appreciated.
When I push the button on handlebar it does nothing.
I cant even here the actuator moving so i know it is not getting the signal.
I have a 2002 Yamaha Kodiak Ultramatic.
thanks for reading this and any help would be appreciated !!
well i just went out to garage and took a peak.
there was a 3amp fuse blown so i put another in and as soon as i turned it on she popped also!
I then put a ten amp fuse in to see if it would work and voila!! It works fine but i know i cant run it with a ten amp fuse as i can fry something else . sooooooooooooooooooooo i am off to the canadian tire (and yes they sell more than just tires)to get somemore fuses.
Most of the time when a fuse blows there is a short in that circuit(Hot touching ground). Do a physical and visual inspection on that circuit so the fuses don't keep blowing
When I take it off the actuator on bottom of bike it does not blow fuse when pushed but ofcoarse it is not trying to push anything either (no Load)
Sooooooo
Maybe my servo motor going bad??
Stuck in 4X4.
update
