ATV Forum banner

1 - 1 of 1 Posts

2 Posts
Discussion Starter · #1 ·
I have a carb on a Suzuki atv. I only know what YouTube has taught me about carbs , so be patient 😀

The pilot jet head broke off, I removed the jet as best I could, including usIng a small drill bit to help get it out

I have two questions, firstly could I have damaged anything at the bottom of the jet housing, I definitely didn’t touch the sides where the thread is?

Secondly when I blow air or carb cleaner through the pilot jet , it comes out of a release hole as per the photo. Is this correct, I don’t understand why that would be there as how does the gas get through to the chamber if there is a much bigger exit hole beforehand?

Any help appreciated

1 - 1 of 1 Posts