ATV Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I have a 2006 Cat 650 V2 and I blew the belt on it a month back. I just put on the new belt today and the dash is still telling me there is no belt. I am also unable to drive faster then 15m/h, it feels like it is being restricted like it does in reverse.

Any ideas on what I haven't done right?
 

·
Banned
Joined
·
377 Posts
Belt problems....

This might work for ya....:thumbsup:

1. Turn the ignition switch to the OFF position; then
disconnect the 4-pin connector.
2. Connect the Reset Connector (p/n 0486-161) into
the forward 4-pin connector; then turn the ignition
switch to the ON position. The belt indicator light
should flash rapidly.
3. Disconnect the belt indicator light switch
connector. The light should flash slowly. Allow
the light to flash for 10 seconds before turning the
ignition switch off.
4. Turn the ignition switch to the OFF position; then
remove the reset connector.
5. Connect the 4-pin connector and the belt indicator
light switch connector; then turn the ignition
switch to the ON position. The belt indicator light
should go off.

or this:


1. Turn the ignition switch to the OFF position; then
disconnect the 4-pin connector and the belt indicator
light switch connector.
2. Install the Reset Connector (p/n 0486-161) into the
forward 4-pin connector; then turn the ignition
switch to ON. Allow the belt indicator light to
flash for 10 seconds or more; then turn the ignition
switch to OFF.
NOTE: The light will flash rapidly for 5 seconds;
then it will flash slowly. Allow the light to flash
slowly for at least 5 seconds before turning the
ignition switch off.
3. Remove the reset connector and connect the 4-pin
connectors and the belt indicator light switch
connector.
4. Turn the ignition switch to the ON position and
confirm
 

·
Registered
Joined
·
2 Posts
Discussion Starter #4
Ya I've seen this before but I am having no luck with it? Maybe I'm jumping the wrong wires. Anyone have a diagram they can post so I can see what I am doing wrong.
 
1 - 5 of 5 Posts
Top