ATV Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I have a 1986 trail boss 250 it had a problem of bad crank seal which was replaced it was filling the stator and pull start with fuel and oil but still ran I put in a new seal and the machine runs fine but burns out the headlight when you give it gas the light gets brighter and brighter till it burns out. I just replaced the voltage regulator but it still burned out the new bulb. ANY IDEAS?
 

·
Registered
Joined
·
28 Posts
I have a 1986 trail boss 250 it had a problem of bad crank seal which was replaced it was filling the stator and pull start with fuel and oil but still ran I put in a new seal and the machine runs fine but burns out the headlight when you give it gas the light gets brighter and brighter till it burns out. I just replaced the voltage regulator but it still burned out the new bulb. ANY IDEAS?
sounds like the stator may have shorted out when the gas+oil got in contact with it,
 
1 - 2 of 2 Posts
Top