Lets see your grizzly
1 - 4 of 4 Posts
1 - 4 of 4 Posts
Join the discussion
Recommended Reading
-
YTM crank bearing removal
Yamaha ATVsHello, have a 84 YTM that I would like to put new crankshaft bearings on. According to a manual it says that if there were to be any damage to the cam chain sprocket that the half of the crankshaft its on would need to be replaced. Can I not press this gear off the crank to replace the bearing...- 0
- 26
-
2003 Big Bear Stalling
Yamaha ATVsGood afternoon! After doing some research on an issue I was having getting my Big Bear to start, I replaced the starter relay. Once the part came in and I installed, she fired right up. Easy fix (I thought)!! I then took her out on a trail to find that she won't stay idling. As soon as I...- 1
- 41
-
bjncj827 · updated
-
1998 Big Bear 350
Yamaha ATVswondering if you guys think i got s good deal/if I bought a good wheeler. I just bought this 98 big bear 350 4X4. its my first wheeler. Thing runs great! shifts great idles great starts right up. the only problem i have with it is every now and then the neutral light wont come on even though i...- 1
- 49
-
gobuffs · updated
-
1998 TIMBERWOLF 4X4
Yamaha ATVsI GOT A 98 TIMBERWOLF LOW HOURS MAYBE 60 OR SO GARAGE KEPT SINCE IT WAS NEW. I HAVE A HARD TIME GETTING IN REVERSE FROM DRIVE AND VICE VERSA, THERE IS NO GRINDING AT ALL AND ITS IN 1ST GEAR BUT I HAVE TO KEEP MOVING THE LEVER BACK AND FORTH UNTIL IT WANTS TO WORK. IS THERE AN ADJUSTMENT?- 4
- 100
-
DBM0361 · updated
-
Getting in gear. 2001 Big Bear
Yamaha ATVsHi all, So I got a 2001 Big Bear 4wd that had been sitting in a yard for years. Had to put a new carb on it, checked the valves, did the oil. Started right up, runs great. So, when I try to shift to,1st, it doesn't go into gear. Neutral light comes back on. I checked to see if the pedal was...- 0
- 42
Join now to ask and comment!