ATV Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
I recently had trouble starting my polaris 800 x2. it would turn over but there would be a clicking noise. I could get it to start with a boost. while boosting it I lost all power to the display. I checked power with a tester and found all fuses were ok and that the key had power but my display would not function. I replaced all fuses (colored) and the cyllanoid but still no display, any Ideas???
 

·
Registered
Joined
·
64 Posts
can we move it to polaris forum fits better there while you were jumping it how many volts were you using too many could have messed up the display just a guess
 

·
Registered
Joined
·
3 Posts
Discussion Starter #3
it was a 12 volt charger, I am not sure about the amps though.
I may have messed up my display, but why didn't the fuses pop first?
Are there more than the fuses above the rad, I checked the 4 they looked good but i replaced them anyway.
What else should I look for, what can I replace to get this atv going again?????
 

·
Registered
Joined
·
64 Posts
i was just guessing i dont know of anything else i would guess mabye the fuse also
 
1 - 4 of 4 Posts
Top