ATV Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
i missed my codes when i was trying to read them,
i have a 07 500 sportsman, how do i re set them to get to read them again,
i tried flicking the key 3 times like i am suppose too but nothing shows....
what has to be done?
 

·
Registered
Joined
·
48 Posts
key on and off three times then on third time leave key on and wait and watch pod and it should show you any codes. if you have no codes it will say end on pod
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top