ATV Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
need suggestions for jetting, mains/pilot/needle....applicable mods:

toomey t5
K&N pod filters
boyesen power reeds
0.040 over

elevation: 1000 ft
riding temp: 15-30*C/59-86*F

suggestions appreciated!

--matt
 

·
Registered
Joined
·
2 Posts
Discussion Starter #3
saber6 said:
You stumped me on that one! I will do some asking around and get back at ya.
P.S. Welcome to the forum!
hey, thanks!

ya i added a whole lot of mods there last year, then while tuning one cylinder blew up. i pressurized the crankcase and there are no leaks there, so it must have been a carb issue.

i found a shop here locally a couple days ago though, and they have a portable exhaust gas analyser that they can hook up to the atv and ride it to check the air/fuel mix, so that is my plan for now. guess i'll just put in the biggest jets i can find and they can go from there!

--matt
 

·
Registered
Joined
·
2 Posts
Jetting help

Ok guys. i got an 87 banshee 0.80 over, trinity 2 into 1 with 33mm carb, tommey t-3 pipes and boysen reeds, at 2,376 ft elevation. the 33mm carb came with a 185 main in it, and its extreamly rich ,what size main jet should i start jetting it at?:dunno: Thanks -Andy
 
1 - 5 of 5 Posts
Top